Casa PescaraBathroom · 3 min
Measuring for a new shower in a Pescara bathroom
Measure the recess, the screen opening and the space outside the shower before committing to a tray or enclosure.
Start with the shape of the recess
Take a wide photo that shows both the shower area and the parts of the bathroom that border it. Sketch the intended footprint and label the edges that meet a full wall, a return or open floor. Record preliminary dimensions at a few marked points. Make it clear whether the tape starts at the face of a tile, a projecting trim or the wall itself. This is especially helpful where an old screen covers the corners. Include a photo from floor level if a raised edge or an irregular return is difficult to see. The fitter can use your notes to locate the dimensions that need confirming on site.
Check the clear opening
The size printed on an enclosure label tells you little about how much space you will have when you step in. Look for the drawing that gives the clear entrance on the chosen screen. Mark where you will stand while opening it and which way you will turn. A hinged screen needs space through its swing. A sliding screen can leave you with a narrower opening than the footprint suggests. Account for handles, tracks and the bathroom door at the same time. Tell the surveyor about any balance or mobility needs so that an apparently workable measurement can be judged against the way the shower will actually be used.
Rehearse the dry side
Mark the proposed perimeter with removable tape and put a towel where you expect to reach for it. Step out along the proposed route, then try getting to the screen for routine cleaning. Ask someone to open the vanity while you stand beside the shower. You may discover that moving the opening makes a bigger practical difference than increasing the footprint. Repeat the test with the current layout and compare the awkward points. Photograph the most useful arrangement, marking which edge is the entrance and where you expect the screen to end. These small decisions are easier to explain while the room still has its familiar furniture in place.
Confirm dimensions at the correct stage
Label every dimension you have taken as a measurement of the existing room. The installer may need to check again after removal or measure between completed finishes before a screen is ordered. Ask which dimensions control the tray order and which control the glass. Record the reference surfaces and make sure everyone is working from the same version of the drawing. This matters when the finish is changing or the walls need to be prepared before installation. Keep the product drawings alongside the survey notes and ask the supplier to confirm the exact configuration being quoted, including the handed version where it applies.
Ask about each junction
Discuss where the shower meets the bathroom floor, where the screen lands on the wall and where a person stands to reach the controls. Find out what access will be available for routine care of the waste. If you want a niche, mark it on a front view so it can be checked against the screen and fittings. In the quote request, describe what matters most to you. An easy entrance, a clear route to the toilet and a useful drying area can call for different compromises. Ask the contractor to show how the proposed combination deals with those priorities before you approve the order.
